RCM-070 7 Button RF Wireless Push Button Wall Plate
Designed for use with 3 or 4 channel constant voltage LED fittings and 3 or 4 channel LED tape light with common +ve and individual -ve connections. Maximum wattage of 120w when used as 4 channel or 90w with 3 channel for 12V d.c. fittings or 240w (60w per channel) for 24V d.c. fittings.
Requires a suitable external d.c. power supply (normally the power supply that would be supplied with the fitting for a non-dimming application).
Programmed using either an RCM/RCP RF wallplate or the RASOFT PC software suite, the unit stores the house, room and channel address plus 16 preset scene levels in non volatile memory.
The RLED30CV4 dimmer can be controlled from any Rako transmitter such as RCM/RCP wallplates, RAH handhelds and Bridge modules and forms the foundation of any Rako scene-set system. For more information on dimming LEDs refer to Rako's application sheet 'Controlling LED Lighting With Rako Dimmers and Modules'.
|Dimensions||172mm x 46mm x 40mm|
|Input Supply||12 or 24v DC|
|Housing||UL VO ABS|
|Climate Range||Temperature +2°C to +40°C; Humidity +5% to 95% non condensing|
|Connections||2 Way screw terminals for 12-24v d.c. supply. 6 Way screw terminals for load.|
|Protection||Reverse polarity input protection. Output current limit protection|
|Load Types||4 Channel constant voltage LED fittings and tapelight|
|Maximum Load||12v DC 3 Channel @ 90w; 12v DC 4 Channel @ 120w; 24v DC 3 Channel @ 180w; 24v DC 4 Channel @ 240w|
|Standards||Emissions - EN61000-6-3 : 2001; Immunity - EN61000-6-1 : 2001|
|Communication||Rakom coded fm radio, 433.9MHz|
|Memory||Flash memory (non volatile)|
Complete your system
Savi store think you might like some of these products too
RMS800 800W In-Line RF Switch Module for Non-dimmable Loads
The RMS800 is a remote switching unit for controlling non-dimmable loads in your wireless Rako system, suitable for controlling circuits with a load of up to 800W.
RMT500 500W In-Line RF Dimmer for Trailing Edge Dimmable Loads
THE RMT800 IS A REMOTE dimmer FOR CONTROLLING DIMMABLE LOADS IN YOUR WIRELESS RAKO SYSTEM, SUITABLE FOR CONTROLLING CIRCUITS WITH A LOAD OF UP TO 500W, you'll need an RMT500 per circuit.
RA-Bridge Wireless Programming Interface with Ethernet Link
The RA-Bridge can be used in any wireless Rako system to add smartphone/tablet control to your system. You only need one bridge per system.
RCM-070 7 Button Keypad with Screwless Faceplate
This keypad is for use in Wireless Rako systems; allowing you to select 4 scenes, off and manually raise/lower the scene lighting levels. It includes a screwless faceplate for a clean, modern finish.